Cino PL680BT HC - Manual (Page 17)

W
ir
eless FuzzyScan
R
efer
ence Man
ual
Getting Started
9
Use FuzzyScan in HID Mode
Ensure the battery is fully charged. Power on the scanner by pressing the Trigger key within radio range if the scanner is
power-off or in sleep state, and ensure the status indicator of scanner gives alternative red and green blinks (in
“Uninstall” state). If the scanner is not in uninstall state, please scan the “Uninstall” command first.
Uninstall
If your remote host is equipped with latest Bluetooth drivers, or it’s an iOS or Android device, you are recommended to
use “HID Mode” for quick pairing. If necessary, you may use “HID Mode with Passkey” to establish a more secure
connection, If you frequently experienced the problem in using HID mode, please try “ HID Legacy Mode” instead.
HID Mode
HID Legacy Mode HID Mode with Passkey
Once you scan one of above commands, the link indicator of scanner will blink blue 3 times per 2 seconds during
searching process. You have to execute the Bluetooth Discovery procedure to find available Bluetooth device, then select
“F(L/A)xxxBT-xxxx” or “PF(L/A)xxxBT-xxx”.
If you use “HID Mode”, please go to step 5.
If you use “HID Mode with Passkey”, you will be requested to enter the Passkey (PIN) on the remote host. Please enter
the Passkey (PIN) accordingly by scanning the “Option Code” (Page 97), and then scan the “FIN (Finish)” to end the
Passkey entry, then go to step 5.
If you scan “HID Legacy Mode”, the Passkey (PIN) may be requested. Please enter “00000000” (default setting). You will
see “Keyboard on F(L/A)xxxBT-xxxx” or “Keyboard on PF(L/A)xxxBT-xxxx”. Please double click this HID service to
establish the connection between scanner and remote host device.
The scanner will emit 4 beeps in ascending tone to indicate the connection is established. At the same time, the link
indicator of scanner will blink blue once per 2.5 seconds to indicate the scanner is in radio-connected state.
Please note that if the scanner is not connected to the host device within 1 minute after scanning the above command,,
the scanner will go to sleep automatically. You can just press the trigger to wake up the scanner to continue the
installation.
The installation procedure may vary depending on different remote host devices, operating systems and the Bluetooth
drivers. Please consult your professional IT consultant to obtain necessary support. For more detailed information,
please visit CINO website.