Cino PL680BT HC - Manual (Page 27)

W
ir
eless FuzzyScan
R
efer
ence Man
ual
Configure Your FuzzyScan
19
Scan
“END”
FuzzyScan will exit programming mode, and store all
parameters in Flash Memory ASIC or non-volatile memory,
then issue the completion beeping.
Scan
“PROGRAM”
FuzzyScan will enter programming mode,
and inhibit all non-programming functions.
Scan
“SYSLIST”
FuzzyScan will list the product information and
revision number to host via selected host interface,
then issue the completion beeping.
Scan
“ M_DEFAULT ”
FuzzyScan will recover all programmable
parameters into factory preset configurations,
then issue the completion beeping.
Program & End
Please note that the FuzzyScan will take 3-4 seconds to
store parameters in internal Flash Memory ASIC or
non-volatile memory after you scan the “END”. Please
don’t turn off the power before the completion beeping. It
may destroy all configured parameters.
System List, Group & Master Default