Station ground – EXFO MaxTester 635 User Manual
Page 126
Multimeter Tests
118
MAX-635
Station Ground
Station Ground
The Station Ground test measures and displays the
resistance value and pass/fail status of the ground
resistance between the MaxTester and the CO
(Central Office). The test uses Tip (A), Ring (B), and
Ground (Earth) leads and measures isolation
resistance between the wires and to ground.
Current Group is the current test group name, for
example Multimeter.
Current Test displays the test being measured.
Here you can switch to another Multimeter test
from the given list. However, this action will
terminate the ongoing measurement test.
Threshold Settings button opens a new page that allows you to set the
Ground Resistance Threshold for the test.
Show hookup diagram on test setup - If Yes, the Confirmation page
is prompted before every Station Ground test is started. Select No to
hide the diagram next time you run the test.
Hookup Diagram button opens a Confirmation
page displaying how to connect your leads at the
beginning of the test. The hookup diagram uses
the following graphic and textual components:
Proceed button closes the hookup diagram
prompt and starts the test.
Cancel button closes the hookup diagram
prompt only.