EXFO MaxTester 635 - Manual (Page 258)

Setting Up DSL/IP Tests
250 MAX-635
Test Configuration
Connection Setup
The Connection Setup tab allows you to configure the
line and access modes, etc of your test dependent on
your unit’s Software Options and model
Information.
The A2XAA or V2XAA unit does Annex A and Bonding.
Annex A is on pair 1 and bonding uses pair 1 and
pair 2.

The Test Interface setup options for A2XAA or
V2XAA modules are the following:

ADSL2+ - if VDSL2 option disabled.

VDSL2/ADSL2+ - if VDSL2 option enabled

ADSLMulti supports G.DMT, T1.413, and G.Lite.

ADSL2+ Bonding - if VDSL2 option disabled, Bonding option
enabled.

VDSL2/ADSL2+ Bonding - if VDSL2 and Bonding options enabled.

VDSL2-30a - if VDSL2 option enabled.
The VA2XAB unit does Annex A and Annex B. Annex A is on pair 2 and
Annex B is on pair 1.

The Test Interface setup options for the VA2XAB module are the
following:

ADSL2+ (xB/P1) - if VDSL2 option disabled, Annex B mode.

ADSL2+ (xA/P2) - if VDSL2 option disabled, Annex A mode.

VDSL2/ADSL2+ (xB/P1) - if VDSL2 option enabled, Annex B mode.

VDSL2/ADSL2+ (xA/P2) - if VDSL2 option enabled, Annex A mode.

ADSLMulti (xB/P1) - supports G.DMT only.