EXFO MaxTester 635 - Manual (Page 259)

Setting Up DSL/IP Tests
Copper and VDSL2/ADSL2+ Multi-play Test Set 251
Test Configuration

ADSL2Multi (xA/P2) - support G.dmt and T1.413 only.

VDSL Bonding - if VDSL2 and Bonding options are enabled.

VDSL2-30a (P1) - if VDSL2 option is enabled.

Annex M allows you to Enable/Disable this option when Test
Interface is ADSL2+ (xA/P2) or VDSL2/ADSL2+ (xA/P2).

Annex J allows you to Enable/Disable this option when Test Interface
is ADSL2+ (xB/P1) or VDSL2/ADSL2+ (xB/P1).

ADSL Transport displays the transport type options: PTM (packet
transfer mode), ATM (asynchronous transfer mode), or ATM and PTM.

Access Mode options are dependent on the Test Interface selection:

If ADSL2+, ADSLMulti, and VDSL2/ADSL2+- available options are
Sync Only, Bridged (not in Auto Test), DHCP, Static, PPPoE, PPPoA,
IPoA.

If ADSL2+ Bonding and VDSL2 Bonding - available options are
Sync Only, Bridged (not in Auto Test), DHCP, Static, PPPoE.

For Ethernet - available options are Bridged, DHCP, Static, PPPoE.

Auto Resync allows you to Enable the SyncLossCounter as the
Pass/Fail criteria. When SyncLossCounter+1 is reached, the test will
have fail status.
If Auto Resync is disabled, any time the test loses sync, the result status
will be fail and the test will stop automatically.

Sync Timeout Period enables you to enter the duration, between
2 and 30 minutes, to run a DSL test from activation to reaching
Show Time.

Keep Sync Time is either:

Continuous where the test runs until you manually stop it, or

User Defined where you can set a Keep Sync Time Period.
Default is 5 minutes.