EXFO MaxTester 635 - Manual (Page 263)

Setting Up DSL/IP Tests
Copper and VDSL2/ADSL2+ Multi-play Test Set 255
Test Configuration
LAN Setup
The LAN Setup tab is available only in Manual Test
Setup and when the Access Mode set in Connection
Setup is not Sync Only. LAN Setup allows you to
configure the parameters required when working in
Pass Through Mode, and the LAN (local area
network) is connected to the external device which
supports 10/100 Ethernet.
This tab is not available in Auto Test Setup.

Pass Through Mode - Enable or Disable.

LAN IP Address is the local network IP address of
the unit.
Note: If the DSL WAN has an IP address on a specific subnet (for example
192.168.x.y) and the Ethernet LAN port is enabled, configure the default
LAN IP address to a different subnet (for example 10.0.x.y) to avoid IP
communication problems.

Subnet Mask is the network address mask used to identify if the IP
address is within the same local area network.

DHCP Server enables the dynamic host configuration protocol (DHCP)
mode for the LAN side of the connection.

Platform Ip Address displays the IP address of the unit’s platform
when the DHCP Server is disabled.
To configure LAN setup values:
1. Press the up/down arrows to select the desired parameter.
2. Press the left/right arrow keys to view and select the options.
OR
3. Press on a value to open a list box of options or the alphanumeric
editor screen and use the navigation keys to scroll through.