Altera HyperTransport MegaCore Function - Manual (Page 14)

2–6 Chapter 2: Getting Started
MegaCore Function Walkthrough
HyperTransport MegaCore Function User Guide © November 2009 Altera Corporation
2. Set the target Altera device family and the values for the read-only
HyperTransport configuration registers on the Device Family & Read-Only
Registers
tab. For this walkthrough, use the default settings, which are shown in
Figure 2–5 . For more information about these parameters, refer to Table A–1 on
page A–1 .
3. Click Next. The Base Address Registers tab appears.
4. On the Base Address Registers tab, configure the HyperTransport BARs that
define the address ranges of memory read and write request packets that your
application claims from the HyperTransport interface. For this walkthrough, use
the default settings, which are shown in
Figure 2–6 . For more information about
the parameters modified by these settings, refer to Table A–2 on page A–2 .
Figure 2–5. Parameterize—Device Family and Read-Only Registers