Altera HyperTransport MegaCore Function - Manual (Page 15)

Chapter 2: Getting Started 2–7
MegaCore Function Walkthrough
© November 2009 Altera Corporation HyperTransport MegaCore Function User Guide
5. Click Next. The Clocking Options tab displays, as shown in Figure 2–7 .
6. You set the clocking options for your application on the Clocking Options tab. For
more information about the available options, refer to “Clocking Options” on
page 3–7 and Table A–3 on page A–3 . For this walkthrough, use the default
settings, which are shown in Figure 2–7 .
1 HyperTransport link clock frequencies of 500 MHz are only supported in
Stratix II and Stratix II GX devices.
Figure 2–6. Parameterize—Base Address Registers Tab