Setup elements, Setup elements –16 – Altera Cyclone V E FPGA Development Board User Manual
Page 24
2–16
Chapter 2: Board Components
Setup Elements
Cyclone V E FPGA Development Board
March 2013
Altera Corporation
Reference Manual
Setup Elements
The development board includes several different kinds of setup elements. This
section describes the following setup elements:
■
Board settings DIP switch
■
JTAG settings DIP switch
■
CPU reset push button
■
MAX V reset push button
■
Program configuration push button
■
Program select push button
D11, D12
D13, D14
JTAG_RX, JTAG_TX
SC_RX, SC_TX
2.5-V
Green LEDs. Illuminates to indicate USB-Blaster II receive and
transmit activities.
D1
ENETA_LED_TX
2.5-V
Green LED. Illuminates to indicate Ethernet PHY transmit activity.
Driven by the Marvell 88E1111 PHY.
D2
ENETA_LED_RX
2.5-V
Green LED. Illuminates to indicate Ethernet PHY receive activity.
Driven by the Marvell 88E1111 PHY.
D5
ENETA_LED_LINK10
2.5-V
Green LED. Illuminates to indicate Ethernet linked at 10 Mbps
connection speed. Driven by the Marvell 88E1111 PHY.
D4
ENETA_LED_LINK100
2.5-V
Green LED. Illuminates to indicate Ethernet linked at 100 Mbps
connection speed. Driven by the Marvell 88E1111 PHY.
D3
ENETA_LED_LINK1000
2.5-V
Green LED. Illuminates to indicate Ethernet linked at 1000 Mbps
connection speed. Driven by the Marvell 88E1111 PHY.
D19
ENETB_LED_TX
2.5-V
Green LED. Illuminates to indicate Ethernet PHY B transmit activity.
Driven by the Marvell 88E1111 PHY.
D22
ENETB_LED_RX
2.5-V
Green LED. Illuminates to indicate Ethernet PHY B receive activity.
Driven by the Marvell 88E1111 PHY.
D24
ENETB_LED_LINK10
2.5-V
Green LED. Illuminates to indicate Ethernet B linked at 10 Mbps
connection speed. Driven by the Marvell 88E1111 PHY.
D20
ENETB_LED_LINK100
2.5-V
Green LED. Illuminates to indicate Ethernet B linked at 100 Mbps
connection speed. Driven by the Marvell 88E1111 PHY.
D21
ENETB_LED_LINK1000
2.5-V
Green LED. Illuminates to indicate Ethernet B linked at 1000 Mbps
connection speed. Driven by the Marvell 88E1111 PHY.
D15, D16
USB_UART_TX_TOGGLE,
USB_UART_RX_TOGGLE
2.5-V
Green LED. Illuminates to indicate USB_UART receive and transmit
activities.
D23, D24
UART_RXD_LED,
UART_TXD_LED
2.5-V
Green LED. Illuminates to indicate UART receive and transmit
activities.
D3
HSMA_PRSNTn
3.3-V
Green LED. Illuminates when HSMC port has a board or cable
plugged-in such that pin 160 becomes grounded. Driven by the
add-in card.
Table 2–7. Board-Specific LEDs (Part 2 of 2)
Board
Reference
Schematic Signal Name
I/O
Standard
Description