Altera Cyclone V E FPGA Development Board - Manual (Page 51)

Chapter 2: Board Components 2–43
Power Supply
March 2013 Altera Corporation Cyclone V E FPGA Development Board
Reference Manual
Power Measurement
There are eight power supply rails that have on-board current sense capabilities using
24-bit differential ADC devices. Precision sense resistors split the ADC devices and
rails from the primary supply plane for the ADC to measure current. A SPI bus
connects these ADC devices to the MAX V CPLD 5M2210 System Controller.
Figure 2–10 shows the block diagram for the power measurement circuitry.
Table 2–29 lists the targeted rails. The schematic signal name column specifies the
name of the rail being measured while the device pin column specifies the devices
attached to the rail.
Figure 2–10. Power Measurement Circuit
SCK
SPI Bus
DSI
DSO
CSn
8 Ch.
Power Supply Load #0-7
R
SENSE
MAX V CPLD
5M2210
System
Controller
Cyclone V E
FPGA
To User PC
JTAG Chain
Feedback
14-pin
2x16
Character
LCD
E
RW
RS
D(0:7)
Supply
#0-7
EPM570
USB
PHY
Embedded
USB-Blaster II
Table 2–29. Power Measurement Rails
Channel Schematic Signal Name Voltage (V) Device Pin Description
1 VCC 1.1 VCC FPGA core power
2 VCCAUX 2.5 VCC_AUX Auxiliary
3 VCCA_FPLL 2.5 VCCA_FPLL PLL analog power
5 VCCIO_VCCPD_2.5V 2.5
VCCPD3B4A,
VCCPD5A,
VCCPD5B,
VCCPD6A,
VCCPD7A8A
I/O pre-drivers banks 3B, 4A, 5A, 5B, 6A,
7A, and 8A
VCCIO3B,
VCCIO6A,
VCCIO7A,
VCCIO8A
VCC I/O banks 3B, 6A, 7A, and 8A
7 VCCIO_1.2V 1.2
VCCIO5A,
VCCIO5B,
VCC I/O banks 5A and 5B (LPDDR2)
8 VCCIO_1.5V 1.5 VCCIO_4A VCC I/O bank 4A (DDR3)