Casella CEL CEL-296 - Manual (Page 44)

10. Repeat this process until all frequency bands have been
recalled (and recorded).
11. Repeat steps 2, 3, and 4 above to specify another memory
location for recall.
Alternatively, use step 6 to change the bandwidth so that the
other set of data can be recalled from the same location.
5.2 Analysis Using Instruments Not Equipped With the Low
Power Serial Interface
The filter set can be used for frequency analysis only when
connected to a suitable measuring Instrument, and both must have
power available. This arrangement will allow any of the sound
parameters determined by the measuring Instrument to be analyzed.
When the measuring arrangement Is also connected to a recording
instrument such as the CEL-160 Graphic Level Recorder, frequency
scanning can be performed under the control of the recorder, which
then records the Individual levels In each band.
Note that Interface equipped Instruments may also be used with ma-
nual or remote frequency scanning once they have been prepared
for use as described in Section 5.1.1.
5.2.1 Preparation for Use With Measuring Instruments Not
Equipped With the Low Power Serial Interface
Operation with these instruments is commenced as follows.
1.
Ensure that all instruments are switched OFF.
Page 44 CEL-296/3 Operator Handbook CEL Instruments Ltd