Junger Audio MIX4 Small Desktop Mixer - Manual (Page 12)

Jünger Audio-Studiotechnik GmbH
page 9
Operation
When switched on, the MIX4 starts up in the Mix mode :
Depending on the Setup, the Channel Buttons are PFL / MUTE / START or HYBRID and the
Channel Rotary knob acquire a GAIN / PAN / BALANCE / Prefade or Postfade function.
Turning a Channel Rotary Knob changes the gain of the respective MIX4 Channel Strip by + 15dB, as shown
here for Channel Strip B (#2), with the GAIN set to +6 dB :
L C R 1 2 3 4 L C R 1 2 3 4 L C R 1 2 3 4 L C R 1 2 3 4
- - -
^
x
G A I N + 6
- - x - - x
M i c 1 T e l e f o n C D 3 J i n g l e 1
PFL PFL PFL PFL
Important note! After two seconds of no turning of the knob, the display changes back to the Mix mode
display, like the other three Strips show in this example.
PAN / BALANCE mode :
A push on the Channel Rotary Knob switches it to the PAN / BALANCE mode.
When a mono source - underlined L or R or C - is assigned to the MIX4 Channel Strip it is a
PAN function (This might be used when you have say two microphones in an interview situation, with
one panned to the left, the other to the right).
When a stereo source - L or R or C not underlined - is assigned, a BALANCE control is performed.
L C R 1 2 3 4 L C R 1 2 3 4 L C R 1 2 3 4 L C R 1 2 3 4
_____ | ____________________ - - x - - x - - x
M I C 1 T e l e f o n C D 3 J i n g l e 1
PFL PFL PFL PFL
The vertical line marks :
the position of the (mono) source within the sound image.
or
the balance of the stereo signal.
Important note! After two seconds of no turning of the knob, the display changes back to the mix mode
display, like the other three Strips show in this example.