Junger Audio MIX4 Small Desktop Mixer - Manual (Page 43)

Jünger Audio-Studiotechnik GmbH
page 40
The pictures below shows the display for 3push mode :
The first push on the Channel Rotary Knob will
select the left channel :
LEFT
of the source GR0 CH34,
thus channel 3 / group 0.
The second push on the Channel Rotary Knob will
select the right channel :
RIGHT
of the source GR0 CH34,
thus channel 4 / group 0.
The third push on the Channel Rotary Knob selects
both channels again :
STEREO
of the source GR0 CH34,
thus the channels 3,4 / group 0.
After leaving the <SRCE> selection mode, underscores in the display will show the status of the sources
selected for the respective channel strip :
GR0 CH1 (the label has been assigned by set up
software), the left channel of the pair
CH12, is selected for Channel Strip A
GR0 CH2, the right channel of
the pair CH12, is selected for Channel Strip B.
GR0 CH34 are in stereo mode and selected for Channel Strip C - no underscore.