Junger Audio MIX4 Small Desktop Mixer - Manual (Page 23)

Jünger Audio-Studiotechnik GmbH
page 20
PFL Options
The MIX4 offers several PFL modes including summing PFL.
The selection is made from the Desktop-Remote.
Press the <MON> button :
L C R 1 2 3 4 L C R 1 2 3 4 L C R 1 2 3 4 L C R 1 2 3 4
T A L K B A C K H - P H O N E 1 E x c l P F L G E N : o f f
G A I N + 0 G A I N - 0 - 2 2 d B
On Channel Strip C one may now select the different PFL modes by turning that Rotary Knob :
Excl PFL : blank Exclusive PFL - only one channel can be monitored in PFL mode.
Excl PFL : FdrOff If one opens the fader PFL will turned off and will stay off.
Excl PFL : FdrOffOn If one opens the fader PFL will turned off and on again if fader is closed.
Sum PFL : blank Summing PFL - pressing PFL button will add that Channel Strip
to the PFL bus. Pressing the button again will take that
Channel Strip away from the PFL bus.
Sum PFL : FdrOff If one opens a fader summing PFL will be turned off and will stay off.
Sum PFL : FdrOffOn If one opens a fader summing PFL will be turned off and on again
if fader is closed.
1kHz Test Ton Generator
There is a test tone function available for the bus outputs of the MIX4.
L C R 1 2 3 4 L C R 1 2 3 4 L C R 1 2 3 4 L C R 1 2 3 4
T A L K B A C K H - P H O N E 1 E x c l P F L G E N : o f f
G A I N + 0 G A I N - 0 - 2 2 d B
On Channel Strip D one can turn the 1kHz generator function on and off by pushing the Rotary Knob.
Different levels for the test tone can be selected by turning that Knob :
Possible settings are : -22dFS, -20dBFS, -18dBFS, -15dBFS, -9dBFS, -6dBFS, 0dBFS
If you turn the generator on you will monitor it automatically via the monitor section of the MIX4.
You can decide now on which bus output the test tone is present. Therefore you must press the respective
Bus Button. This button starts blinking green as long as you press it again.
Important note! When the <MON> button is active and you press a <BUSx> button, the respective physical
output (analog and digital) is switched to the generator – i.e. the MIX signal from that bus is interrupted!
It is indicated by blinking green of the <BUSx> button.