Junger Audio MIX4 Small Desktop Mixer - Manual (Page 17)

Jünger Audio-Studiotechnik GmbH
page 14
L C R 1 2 3 4 L C R 1 2 3 4 L C R 1 2 3 4 L C R 1 2 3 4
- - -
^
x
S T E R E O
- - x - - x
M i c 1 T i e L i n E 1 C D 3 J i n g l e 1
PFL PFL PFL PFL
Pressing that Channel Button will give you control of the external router so you can select the desired input
for the MIX4. The channel button will blink yellow or yellow/red to indicated that you are controlling
the external router. By turning the Rotary Knob one will select router sources (blinking yellow) or groups of
sources (blinking yellow/red) first, depending on the external router brand / type :
L C R 1 2 3 4 L C R 1 2 3 4 L C R 1 2 3 4 L C R 1 2 3 4
- - -
^
x
G R P D A T
- - x - - x
M i c 1 D A T P L 4 C D 3 J i n g l e 1
PFL PFL PFL PFL
The top line now shows the group name and the bottom line now shows the source name of the selected
source of the external router. The selected source will be available for that input (and therefore for the
Channel Strip of the MIX4) immediately.
Pushing the Channel Button again will switch back to initial source selection mode and the LED of the
Channel Button will turn off. In this case the display will show the name of the tie-line again not the name of
the router source! But if you push <SRCE> instead of the channel button at this time the display will show
the router source name.
If router sources are organized in groups that second push will lead one level down to select a source within
a pre-selected group (see above). In this case the channel button will blink yellow now to indicate that
turning the Rotary Knob will now select a source from that group.
Pushing <SOURCE> will terminate the function.
Notes about different control concepts for router from different manufactures :
Klotz VADIS II
In this case, 16 sources for each MIX4, connected to a VADIS system, must be pre-selected in within the “Junger Audio DDE client”
(see extra description for VADIS operation). Thus you will get 16 more (external) sources for the MIX4.
LAWO / Mandozzi / DHD
By use of Setup software, 16 groups by 8 sources can be pre-selected for the respective system which the particular MIX4 can
select afterwards. There are two levels of controlling such a router. One needs to select one of the groups first and afterwards one
of the sources from that group.