Junger Audio MIX4 Small Desktop Mixer - Manual (Page 56)

Jünger Audio-Studiotechnik GmbH
page 53
The details of connections are stored by the registry of the MS Windows™ operating system.
If you have lots of connections in use and you would like to transfer such information to a different PC, you
must export the registry key which you will find here :
HKEY_LOCAL_MACHINE\SOFTWARE\Juenger Audio\SDM4Base\
The example below assumes you are about to mange operator profiles :
After you have selected “Operator Profiles” and have pressed <Receive> all operator names have been
read from the device. The list entries 2 - 5 have been checked. By pressing <Import> the data sets have
been loaded to the “Workspace”. Over there they are checked again.
By pressing <Save As> you can now either store it to a new file or you can open an existing one and have a
look which positions within the file are empty or due to overwrite. But you can also read a list of
operator profiles from a different device to have a look if there is “room”.
If necessary you can move sets of data to different positions in the “Workspace”, to store it into the left hand
opened file by pressing <Save> or to move it by pressing <Send> into the device displayed left side.
Therefore you must move the label via drag and drop to the desired position of the list. The list entry possibly
existing will automatically be moved to the next position. To store or send such list entries you must mark the
appropriate check boxes.
In the left window the list entry „Eckhard“ is high lighted. Therefore the label of the bottom left soft button
changes to <Load Eckhard>. If you push it, this operator will be remotely logged in for the selected device.