Junger Audio MIX4 Small Desktop Mixer - Manual (Page 32)

Jünger Audio-Studiotechnik GmbH
page 29
Headphones pane
Both headphone outputs have independent amplifiers and can be adapted individually by the MIX4 remote to
fit the desired listening conditions. The maximum output level can be set to +15 dBu.
The signal monitored may be selected “Fixed to” one of the “BUSses” or the “PFL” selector or to
”Follow Monitor Selection”.
The maximum possible level on the headphone outputs may be set here as well.
Monitor Line Out pane
There is one stereo monitor line output for connection to a set of active speakers (maximum level + 6dBu).
Setup options are the same as for Headphones except the maximum output level (+6 dBu).
Scrolling down the page reveals additional panes :
Aux Out 1 (digital) pane
and
Aux Out 2 (analog) pane
These have source selections as above plus all sources from the input router of the MIX4.
AUX 2 has a “max. Output Level” adjustment.
Important note! These are auxiliary outputs for general purpose (metering, external talkback send).
Do not be confused Aux Out with the phrase “aux send” normally used for pre / post fade (aux) sends.
The offset gains for all sources are not active for the “Fixed to [source x]” option. You will get the “raw”
level of the selected input.
If one of the above outputs is set to “PFL” it becomes an independent PFL output. I.e. the PFL signal
will only appear at that output and will be no longer part of the monitor root.