AMETEK SL Series Calibration Manual - Manual (Page 31)

Elgar Electronics Corporation Calibration
2.5.4 CR M
ODE
, L
EVEL
H
IGH
, R
ANGE
II O
FFSET AND
G
AIN
, I
TEMS
27
AND
28
1. LOAD OFF.
2.
Press the
© key to go to Item 27.
3. Set the power supply voltage and the DC Voltage Standard to the
VSENSE Input value shown in Table 2-27 for the model being
calibrated.
4. PRES ON.
5.
Set the current to the Current Setting value in Table 2-27 for the
model being calibrated.
6. PRES OFF.
7.
LOAD ON.
8. Adjust using the
† keys until the DAM reading and the current
setting match.
MODEL Resistance Setting VSENSE Input Current Setting
SLM-60-30-150 0.1068Ω 3.204V 30.000A
SLM-60-60-300 0.0534Ω 3.204V 60.000A
SLM-250-10-300 1.3334Ω 13.334V 10.000A
SLM-500-10-300 2.680Ω 26.80V 5.000A
SLM-60-15-75 0.2134Ω 3.201V 15.000A
SLH-60-120-600 0.0268 Ω 3.216V 120.00A
SLH-60-120-1200 0.0268 Ω 3.216V 120.00A
SLH-60-120-1800 0.0268 Ω 3.216V 120.00A
SLH-60-240-1200 0.0133 Ω 3.216V 240.00A
SLH-60-240-1800 0.0134 Ω 3.216V 240.00A
SLH-60-360-1800 0.0088 Ω 3.168V 360.00A
SLH-500-60-1800 0.4444Ω 26.666V 60.00A
Table 2-27. CR Mode, Level High, Range II Offset Adjustment Settings (Item 27)
9.
LOAD OFF.
10. Press the
© key to go to Item 28.
SLM/SLH Calibration Manual 2-23