CITIZEN MG0000 - Manual (Page 29)

4. Alarm Mode
Once this alarm is set (ON), the alarm sounds for approximetely 30 seconds at the same
time every day and "Alarm" is displayed on the display. The alarm can be turned off by
pressing any button when it is sounding. In addition, the alarm tone can be selected from
15 types of alarm sounds when setting the alarm.
A. Alarm ON/OFF and Alarm Monitor
The alarm is switched between ON (set) and OFF (canceled) each time button (B) is
pressed in the alarm mode. Once the alarm has been set, the alarm ON mark
is
displayed in the time mode. When button (B) is pressed continuously in the alarm mode,
you can monitor the selected alarm tone for as long as button (B) is pressed.
B. Setting the Alarm
(1) The watch switches to the correction state (display flashes) when button (C) is pressed
for at least 2 seconds during then the normal display in the alarm mode. The flashing
item can be corrected.
(2) The flashing item changes in the order shown below each time
button (C) is pressed.
(3) The flashing item can be corrected by pressing either button (B)
or button (A).
• Pressing button (B) advances the display by one step at a time, while pressing button (A) moves the
display back by one step at a time. (Pressing either button continuously causes the display to change
rapidly.)
• When button (B) is pressed while in the alarm number selection state (an alarm number is flashing), the
next alarm number is called up each time it is pressed. When button (A) is pressed in the alarm number
selection state, the next alarm number is called up in the reverse order each time it is pressed. Select
"Silent" when you do not want the alarm to sound. In this case, the alarm time is notified only with
"Alarm" on the display.
• You can monitor the alarm corresponding to the flashing alarm number by pressing button (B) or button
(A) in the alarm number selection state for as long as the button is pressed. (The next or previous alarm
number is momentarily displayed the instant the button is pressed, while pressing either button
continuously causes the set alarm to sound.)
(4) Pressing button (D) finalizes the alarm setting.
* The 12 hour or 24 hour format setting is in accordance with the setting in the time mode.
* The watch automatically returns to the normal alarm display when none of the buttons are
pressed for about 3 minutes in the correction state (display flashing).
* The watch can be immediately returned to the normal alarm display by pressing button (D) in
the correction state (display flashing).
* The watch automatically returns to the time mode when none of the buttons are pressed for
about 3 minutes during the normal alarm display.
29
[Alarm ON]
Alarm time
Flashing
Current time
(B)
(C) (C)
( C ) ( B )
( D ) ( A )
( C ) ( B )
( D ) ( A )
[Alarm OFF]
Hours Minutes
Alarm
number