CITIZEN MG0000 - Manual (Page 50)

2. Setting the Time and Date
(1) The watch enters the correction state (display is flashing) when
button (C) is pressed for at least 2 seconds during the time
display or date display.
(2) The flashing item changes in the order shown below each time
button (C) is pressed.
(3) Correct the flashing item by pressing button (B).
• Pressing button (B) advances the display by one step at a time. (Pressing button (B)
continuously causes the display to change rapidly.)
• The watch returns to 00 seconds simultaneous to pressing button (B) while
correcting seconds. (The minutes advance by 1 minute if the seconds are between
30 and 59 seconds at that time.)
• When switching the 12H/24H format, the display switches back and forth between
the 12 hour and 24 hour format each time button (B) is pressed.
(4) Pressing button (D) returns the watch to the normal display.
* The time and date of the main location in the time mode of the standard mode can be
displayed and corrected in the low power mode. Changes made to the time and date in the
low power mode are retained even after returning to the time mode of the standard mode.
* The year can be set from 2000 to 2099.
* Dates such as February 30 that do not actually exist are not displayed even during correction.
* Pay attention to AM (A) and PM (P) when using the 12 hour format.
* The day is corrected automatically by correcting the year, month and date.
* The watch automatically returns to the normal display (time display or date display) when none
of the buttons are pressed for about 3 minutes in the correction state (display flashing).
* The watch can be immediately returned to the normal display by pressing button (D) in the
correction state (display flashing).
50
Contrast
(CONT)
12H/24H format
switching
Date Month
Seconds Minutes Hours Year
Flashing
(C)
(C) (C) (C)
(C)
(C) (C)