Pacific Research Solutions RI-1 User Manual
Page 12
Pacific Research Solutions
RI-1 and PE-1 User Manual
Page 6
Communication
This menu is used to send data to and get data from the controller. You may
also flash the program firmware to the controller. Any one of these functions
may take as long as 3 minutes to complete. Do not interrupt the process once it
is started. The repeater controller is allowed to be in use during the time that
you are sending data to or getting data from the repeater. These data functions
can be performed while the repeater
is in use. You will also find a modem
connect sub window here. This
connection may be used to
communicate to your controller via a
modem.
System
This menu is used to adjust the system, auxiliary, bit output and
password functions. Each sub windows will have a "SEND"
button you can use to send only that window’s data to the
controller.
In the “System Setup” dialog, you can adjust the operation of the
controller and various timers. See the figure to the right.
Commands
This menu is used to set up all types of user commands and allow the editing of macro data. See section 12 for details on user
commands and macro editing.