Pacific Research Solutions RI-1 User Manual
Page 28
Pacific Research Solutions
RI-1 and PE-1 User Manual
Page 22
DEFAULT USER COMMANDS
The controller comes programmed with some default User Commands. See section 12 for details on changing the command
names or the commands themselves. You can use these commands only when the controller is locked in User Mode.
#1
Repeater mode OFF.
*1
Repeater mode ON using NSQ to access repeater.
*2
Repeater mode ON using NSQ and TSQ to access repeater.
#6
Carrier delay OFF.
*6
Carrier delay ON.
#0
Link mode OFF.
*0
Link mode ON, used if you have 2 repeaters tied together.
SETTING UP YOUR STATION ID
You are now ready to change or set up the station identification, ID message. The factory default CW ID is “Hello”. The
following will show you how this ID was programmed into the controller. Once you have reviewed this procedure, you may
want to review section 13 for more details on programming messages before you start programming your own ID. You can also
use this same technique to modify any of the system messages.
Each character of the ID message has a 2-digit command number. See the default CW data table in section 11, S-Command 31
for a list of all CW commands. The data (CW commands) for all messages are stored in the same memory area as the macros.
Take care when entering a new message or changing a message, to avoid damaging other data in the memory. The default
“Hello” message uses the following CW commands:
Character 1 = 01 Start Of Message
Character 2 = 00 Reset Tone Generator defaults
Character 3 = 04 Set Tone Generator 1 to 500 Hz tone
Character 3 = 99 Delay 1 second
Character 6 = 59 CW “H”
Character 7 = 56 CW “E”
Character 8 = 63 CW “L”
Character 9 = 63 CW “L”
Character 10 = 66 CW “O”
Character 11 = 02 End Of Message
As you can see in the above example, all CW commands have a start of message and a end of message. The body of the
message is contained between the start and end.