Pacific Research Solutions RI-1 - Manual (Page 29)

Pacific Research Solutions RI-1 and PE-1 User Manual
Page 23
Review the following procedure to understand how this “Hello” ID was entered into the controller. When you un-key your
radio after each command, you should hear the character number in speech. This will tell you that you did everything correctly.
If you hear an “ERROR”, a mistake was made and the command was aborted.
You can also use the programming software to edit this message. Pick “Triggers” then pick “Messages”, highlight “Station ID”
item 11 then pick “Edit Msg.”. You will see the message edit box as displayed on the right. Use the same message editing
format to enter your message commands as shown below.
S-Command Description
1. 123456 If you are using DTMF, unlock the controller, you are in S-Command mode.
You should notice a different courtesy tone.
2. 63 043 If you are using DMF, S-Command 63 sets the memory data pointer (start line number pointer)
to start line 038. If you are using the programming software, you can use the macro editor to
select the start line.
3. 31 01 S-Command 31, Enter message data into memory, Start Of Message.
4. 31 00 S-Command 31, Enter message data into memory, Reset Tone Generator defaults
5. 31 04 S-Command 31, Enter message data into memory, Set Tone Generator 1 to 500 Hz tone.
6. 31 99 S-Command 31, Enter message data into memory, Delay 1 second
7. 31 59 S-Command 31, Enter message data into memory, CW “H”.
8. 31 56 S-Command 31, Enter message data into memory, CW “E”.
9. 31 63 S-Command 31, Enter message data into memory, CW “L.
10. 31 63 S-Command 31, Enter message data into memory, CW “L.
11. 31 66 S-Command 31, Enter message data into memory, CW “O”.
12. 31 02 S-Command 31, Enter message data into memory, End Of Message.
13. 64 S-Command 64, Terminate the end of this memory segment.
14. If you are using the programming software, pick the “OK” button then pick the “Send” button
to update the controller.
15. 68 043 If you are using DTMF, S-Command 68 will trigger the message or macro at start line 038.
Use this to test your message. If you are using the programming software, you can use the
“Send S-Cmd” dialog box to test this macro.
16. 69 1 If you using DTMF, S-Command 69 1 will lock the controller and save data, you are done.
Now you are ready to enter YOUR ID message. Use the above example to organize your message. It is important to know how
the memory is organized so that you will know what the next available start line will be. The table below shows the default ID
and how the above data was stored into memory.
The same data as above is illustrated
here in the programming software. You
can use the programming software to
modify you ID, using the same syntax
as described above.