Pacific Research Solutions RI-1 User Manual
Page 41
Pacific Research Solutions
RI-1 and PE-1 User Manual
Page 35
S-Cmd 18 RESERVED
S-Cmd 19 GENERATE DTMF OUT
This command is used to regenerate a received DTMF string on the main port transmitter. The data source for this command
can come from decoded DTMF digits or data within a macro. The controller regenerates DTMF tones with 120 ms tone ON
time and 80 ms spacing. Valid DTMF digits are 0 through 9, A, B, C, D, *, #. (If a DTMF digit is used as an alternate
command terminator, that digit may not be used as data in this command). The DTMF regenerate buffer has a maximum length
of 15 DTMF digits. This command can also be used in a macro to generate a DTMF string upon a user command, however,
DTMF B, C and D can not be used do to the special use of these digits within macros.
SYNTAX:
19
[Data]
STORAGE:
RAM
PARAMETERS: Data = 1 to 15 DTMF characters 0 through 9, A, B, C, D, *, #. (B through D are not allowed in macros)
DEFAULT:
N/A
EXAMPLE: 19 1234567890*#
Resends DTMF digits 1234567890*# on main port transmitter
S-Cmd 20 REMOTE BASE INTERFACE MODE
This command is used to set select the mode and type of synthesized radio that will be connected to the controller’s main port.
Currently only EchoLink is supported. We will be adding more radios in the near future.
SYNTAX:
20
[Mode]
STORAGE:
RAM/EEPROM
PARAMETERS: Mode 0 = None: This mode is used for repeater or full duplex link operation.
Mode 1 = EchoLink: In this mode, the controller used the RTS and CTS singles for EchoLink RX and
TX. In this mode, serial data can be sent to EchoLink to select nodes and other features. All of
these signals from the controller are RS-232 levels. No external level converters are needed.
DEFAULT: Mode 0
EXAMPLE: 20 1
Select EchoLink mode
S-Cmd 21 REMOTE BASE USER FUNCTIONS BITS
To be added in the near future.
S-Cmd 22 REMOTE BASE USER FUNCTION BYTE
To be added in the near future.
S-Cmd 23 REMOTE BASE RADIO FUNCTIONS BITS
To be added in the near future.