Unpacking the ri-1, Mounting the ri-1 repeater controller, Interface your receiver and transmitter – Pacific Research Solutions RI-1 User Manual

Page 8

Advertising

Pacific Research Solutions

RI-1 and PE-1 User Manual

Page 2

SECTION 2

QUICK START

This section will cover the basics of installation and programming of your RI-1. You may also need to review section 4 or 5 for
more details on connecting your RI-1 to your repeater. Once you have covered these basics, we recommend that you
thoroughly review the complete manual in order to get the most out of your controller.

UNPACKING THE RI-1

Inspect the carton for the following contents and if any of the items that you have ordered are missing or damaged, notify your
dealer or the factory that shipped the unit to you.

1. RI-1 or PE-1 Repeater controller board with mating DB25S connector.
2. User manual on CD.
3. Mounting hardware.

MOUNTING THE RI-1 REPEATER CONTROLLER

1. An optional single controller chassis is available. Mounting holes are provided for the repeater controller board within the

enclosure.

2. The repeater builder can mount the RI-1 repeater controller in any enclosure of his choice. The enclosure that you select

should be strong enough to mechanically protect the contents. The enclosure should be made of metal with good shielding
properties. We do not recommend the use of a plastic enclosure in a RF environment. Mount the RI-1 unit with #4-40
standoffs on the mounting surface.

3. Avoid installing the RI-1 in the following places:

• Directly above a transmitter or power amplifier because of heat and RF considerations.

• Directly above any power supplies because of heat and 60 Hz coupling into the audio circuits.

INTERFACE YOUR RECEIVER and TRANSMITTER

The RI-1 repeater controller is very easy to interface with your repeater. Before you continue, you need to make the following
connections. All connections are covered with greater details in section 4 of this manual. If you are installing the PE-1, you
should go directly to section 5.

1. +12 Volts DC power source, J1 Pin 5. (Only on the RI-1, the PE-1 gets its power from the RI-300)
2. DC power ground, J1 Pin 21, J1 Pin 5.
3. Receiver audio, J1 Pin 2.
4. Receiver NSQ (Squelch), J1 Pin 6.
5. Receiver TSQ (CTCSS), J1 Pin 7, Optional.
6. Audio return and/or shield, J1 Pin 15.
7. Transmitter audio, J1 Pin 3
8. Transmitter keying circuit (PTT), J1 Pin 4.

See section 4 for more complete details on proper interfacing to your repeater transmitter and receiver.

Audio Input (RX)

Audio-Ground

Digital-Ground

PTT (Open Drain)

Audio Output (TX)

+12V Supply

Radio Data Out

RI-1 Interface Connector

20 21 22 23

5Volts@25mA Out

Radio Data In

Radio Pwr Switch

Radio Pwr Detect

Sypply-Ground

User In 2

User In 1

SLE

SCK

SDA

RS-232 TXD

RS-232 RXD

RS-232 CTS

RS-232 RTS

User Out 1 (Open Drain)

User Out 2 (Open Drain)

TSQ (CTCSS)

NSQ (COS)