Pacific Research Solutions RI-1 User Manual
Page 40
Pacific Research Solutions
RI-1 and PE-1 User Manual
Page 34
S-Cmd 13 USER COMMAND DTMF MODE
You can use this setting to select NSQ and/or TSQ signals to allow decoding of User Commands. This setting is independent
from the repeater or linking operation.
SYNTAX:
13
[Mode]
STORAGE:
RAM/EEPROM
PARAMETERS: Mode 0 = Disable or turn off user command decoding.
Mode 1 = NSQ Only, Mode 2 = TSQ Only, Mode 3 = NSQ and TSQ.
DEFAULT: Mode 1, NSQ
EXAMPLE: 13 3
Use both NSQ and TSQ to process User Commands
S-Cmd 14 SYSTEM COMMAND DTMF MODE
You can use this setting to select NSQ and/or TSQ signals to allow decoding of System Commands. This setting is independent
of the repeater or linking operation.
SYNTAX:
14
[Mode]
STORAGE:
RAM/EEPROM
PARAMETERS: Mode 0 = Disable or turn off user command decoding.
Mode 1 = NSQ Only, Mode 2 = TSQ Only, Mode 3 = NSQ and TSQ.
DEFAULT: Mode 1, NSQ
EXAMPLE: 14 3
Use both NSQ and TSQ to process User Commands
S-Cmd 15 USER COMMAND GROUP DECODE ENABLE
This command is used to turn on or off any one of two groups of User Command. When you build a user command, you are
asked to identify one of two groups into which the command is placed. You can then use this command to enable or disable
any one of the two groups.
SYNTAX: 15 [Group] [Mode]
STORAGE:
RAM/EEPROM
PARAMETERS: Group 0-1 = Each User Command is assigned a group
Mode 0 = Group disable, turn off a user command group.
Mode 1 = Group enable, turn on a user command group.
DEFAULT: Group 0 = 1 (Enable), Group 1 = 0 (Disable)
EXAMPLE: 15 0 0 Disable (turn off) group 0
S-Cmd 16 DTMF INTER-DIGIT TIME
This command sets the maximum time allowed between DTMF digits in a valid command sequence. If the Inter-digit timer
times out before completing a command, the command will be terminated without execution.
SYNTAX:
16
[Data]
STORAGE:
RAM/EEPROM
PARAMETERS: Data 1-99 = Time in Tenths of seconds (1/10 Seconds or 100 ms)
DEFAULT: 35 (3.5 Seconds)
EXAMPLE: 16 50
Sets Inter-digit time to 5.0 Seconds
16 25
Sets Inter-digit time to 2.5 Seconds
S-Cmd 17 DTMF MUTE DELAY TIME
This command sets the time that audio is muted when DTMF tones are decoded. Use S-Command 18 to control the use of
muting for the repeater, auxiliary and telephone audio.
SYNTAX:
17
[Time]
STORAGE:
RAM/EEPROM
PARAMETERS: Data 1-99 = Time in Tenths of seconds (1/10 Seconds or 100 ms)
DEFAULT: 25 (2.5 Seconds)
EXAMPLE: 17 50 Set mute time to 5.0 Seconds