SoundTraxx SurroundTraxx - Manual (Page 60)

SurroundTraxx User’s Guide Configuration Guide Page 2:32 SurroundTraxx User’s Guide Configuration Guide Page 2:33
dispatched, SurroundTraxx may no longer work correctly and will require the
power to by cycled off and back on to restore proper operation. Therefore,
you should only change the BDL setting when no locomotives have been
dispatched.
Once you have the block detector you wish to configure in programming
mode, navigate to the BDL Set-up Menu as follows:
1. From System Monitor mode, push the control knob to display
ROUNDHOUSE. Turn the control knob until the display reads SYSTEM.
Push the control knob to select the System menu.
2. Turn the control knob until the display shows BDL SETUP and push it to
confirm the selection.
3. To first choice in the BDL Setup is ADDRESS. Push the knob to select
this option and then enter the new address. SurroundTraxx will ask you
to confirm the address. Select Y (yes) and push the knob to confirm.
4. To set THE BDL-168's Ops Switch, turn the knob until the display reads
OP SWITCH.
Push the control knob to select this option and then select the ops
switch number you wish to change. Push the control knob again and
rotate the knob to display either THROWN or CLOSED (whichever is
desired) and push to select. SurroundTraxx will ask you to confirm your
selection - push the knob to confirm or turn the knob to respond no (N).
To determine which switches need to be thrown or closed, please refer to
the BDL-168 owner's manual.
OR OR
5. When the address or ops switch has been set, SurroundTraxx'
display will momentarily show "SUCCESS". Please note that this
simply indicates that the data was successfully transmitted over the
LocoNet and you may see this message even if the BDL-168 is not in
programming mode.
6. Change the BDL-168 mode from programming back to operation.
Configuration Guide