Super Systems 9120 - Manual (Page 13)

4574 - SSi 9120 Manual Rev A Page 13 Super Systems Inc
Trip Point 1 Setpoint
This is the trip point 1 setpoint value. The range is –32768 to 32768.
Trip Point 1 Force Value
This is the trip point 1 force value. The range is –32768 to 32768.
Trip Point 1 Direction
This is the trip point 1 direction. The options are: input above setpoint or input below setpoint.
Trip Point 2 Setpoint
This is the trip point 2 setpoint value. The range is –32768 to 32768.
Trip Point 2 Force Value
This is the trip point 2 force value. The range is –32768 to 32768.
Trip Point 2 Direction
This is the trip point 2 direction. The options are: input above setpoint or input below setpoint.
High Input Limit Setpoint
This is the setpoint for the high input limit. The range for this can be –32768 to 32768.
High Input Limit Hysteresis
This is the hysteresis for the high input limit. The range for this can be –32768 to 32768.
Step 6 – Complete Configurator Analog Output Setup Menu Option
Note: This menu item is also located later
in the manual under the
Section 1 – 9120
Configurator Menus section .
The 9120 controller has the option of two
analog outputs. The outputs are ranged
for a 4 – 20 milliamp signal or a 0 – 20
milliamp signal. Each output comes with
a factory default configuration dependent
on the application. Each output can be
modified prior to shipment to your facility
or in the field by a supervisor.
Analog Output Terminals
Analog output 1 – terminals 24 and 25
Analog output 2 – terminals 25 and 26
Assignment
The analog output assignment can be
modified depending on your system
requirements. To change the Assignment
first select which analog output you want
to change by selecting it in the pull-down
menu just below the main menu list.
Clicking on this value will display an input box, and then you can use the pull-down menu to select the desired parameter.
Once selected click OK
and the displayed assignment under Value will be the current assignment type. The following is a
list of the options:
PV 1 retrans
Input 1 retrans