Super Systems 9120 - Manual (Page 7)

4574 - SSi 9120 Manual Rev A Page 7 Super Systems Inc
Area Connection” as seen in the diagram to be
modified. The Properties can be changed by
highlighting the connection and using the right
mouse button to click and select the
Properties
tab or by highlighting the connection and
clicking on Change setting of this connection.
Once the
Local Area Connection Properties
screen is displayed, highlight the Internet
Protocol (TCP/IP) option. Click the Properties
button to display Internet Protocol
(TCP/IP) Properties. On the Internet Protocol
(TCP/IP) Properties tab, you will need to select
the option for Use The Following IP Address.
Enter in the following data on these fields:
IP Address: 192.168.0.209
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.1.1
Note: These fields are suggestions. Contact your IT department to get a
valid IP address, Net Mask, and Gateway for the local computer.
To change the network
settings on your
computer you may need
addition information so
please refer to the
computer manual.
Step 3 – Configure Configurator 2.0 on the local computer
When Configurator starts up for the first time, the user will see the main screen, which will be blank because no
instruments have been set up yet. The first step is to set up an instrument in Configurator.