Super Systems 9120 - Manual (Page 28)

4574 - SSi 9120 Manual Rev A Page 28 Super Systems Inc
Millivolt
Redundant Probe
Simple Nitrider
Dual Loop
Temperature Mode
This value determines the specific temperature scale to be used. Clicking on the value will allow the operator to change
the value. It can be either Degrees °°°°F or degrees °°°°C.
Level 1 Code
Typically, operations used by a supervisor require a level 1 code for access. When a supervisor is logged in, the lock on
the toolbar will be gold, . To change the level 1 passcode, click on the “Level 1 Code” value (range is –32768 to
32767) and an input box will be displayed where the user can select a new value.
Level 2 Code
Typically, operations used by an administrator require a level 2 code for access.
When an administrator is logged in, the
lock on the toolbar will be green, . To change the level 2 passcode, click on the “Level 2 Code” value (range is –
32768 to 32767) and an input box will be displayed where the user can select a new value.
Web Level 1 Code
This value is the supervisor-level passcode for any web-based operations with the 9120 controller. Clicking on the value
will allow the operator to change the value. The range for the passcode is 0 to 9999.
Web Level 2 Code
This value is the administrator-level passcode for any web-based operations with the 9120 controller. Clicking on the
value will allow the operator to change the value. The range for the passcode is 0 to 9999.
Web Change Enable
This will either enable or disable the web change feature, which will allow changes to be made over the web page for the
9120 controller. Clicking on the value will allow the operator to change the value. Select either a 0 (Web Change
Disable) or a 1 (Web Change Enable).
O2 Mode
This value will allow the operator to select the oxygen mode.
Clicking on the value will allow the operator to change the value.
The options are:
% with control
Monitor
Offset with control.
Sample Pump Mode
Remote Setpoint
Remote Setpoint Hysteresis
Sample Pump Mode
This menu option will allow the user to turn the sample pump On or Off. For the HP PVT types (% Carbon, Dewpoint,
Oxygen, Millivolt, and Redundant Probe), there is the option to set a minimum temperature in order for the pump to
run. See the “Minimum Temp/Pump Run” description below.
Remote Setpoint
This option will allow the user to select where the remote setpoint will come from. The options are:
None
Slave 1 PV