Eneo PNR-5304/4TB - Manual (Page 14)

Part 1 – Introduction
14
Rear Panel
1
2 4
@
5
7 !
6 8
9 0 3
1 Factory Reset Button 2 Audio Ports 3 VGA Out Port
4 HDMI Out Port 5 eSATA Port 6 Video In / PoE Ports
7 Network Port 8 Video In / Ext. Port 9 Alarm Connection Ports
0 RS-232 Port ! Power In Port (12V) @ Power In Port (48V)
Rear Panel Connections
Monitor Connection
Connect to the VGA OUT or HDMI port.
Audio Connection
Connect the speakers with a built-in amplifier to the
AUDIO OUT port. Use the AUDIO OUT port to listen to
audio from network cameras.
• This NVR does not feature a built-in audio amplifier
unit and therefore requires the user to purchase a
speaker system with a built-in amplifier separately.
• Check your local laws and regulations on making
audio recordings.
Video Connection
• Video In/PoE Port
Connect network cameras or video encoders to the NVR
using RJ-45 cable (Cat5, Cat5e, or Cat6).
• Green LED on the right will turn on when PoE comes
on line. Orange LED on the left will then flash once a
link has been established.
• If more than 16 cameras from video encoders are
registered on the NVR, video may not be displayed
smoothly in a remote program.