Eneo PNR-5304/4TB - Manual (Page 68)

Part 4 - Search
68
Special characters such as \, /, :, ;, *, ?, !, “, <, >, and | are
not permitted.
• Include Text-In Data: Enabling this option will save
the video clip along with any available text-in data.
• Use Site Info: Adds Site info to the Clip Copy file's
name.
Special characters contained in the location info (such
as \, /, :, ;, *, ?, !, “, <, >, and |) will be replaced with _
when the information is added to the file name.
Selecting Start displays a calculation on the size of the
data to be copied. Check the calculation and then select
Continue to proceed. While Clip Copy is in progress, you
can select Cancel to cancel the process or select Close
to allow the window to run in the background. Selecting
Close does not cancel Clip Copy. Once the process is
complete, you will be prompted with a confirmation
window.
• One-Touch Clip Copy configures the storage range
automatically based on the storage drive's capacity.
If there is insufficient space available on the selected
storage device, you will only be able to Clip Copy
an amount of data equaling the remaining space
available on the storage device.
• The maximum size limit on Clip Copy files is 30GB.
Saving a segment that is more than 2GB in size
produces multiple files that are up to 2GB in size,
each. The maximum size limit for One-Touch Clip
Copy files is 2GB.
• Clip Copy files can be played back on Windows
systems. For more information, refer to the REVO
Remote Pro operation manual.
• For USB flash memory devices, the NVR supports the
FAT32 file format only.
Do not disconnect the USB cable or power off the USB
device while USB Clip Copy is in progress. Doing so
can cause the NVR to malfunction or critically damage
the external USB device's file system. You may be
prompted with an error message when trying to back
up on the device. If so, you will need to restart the NVR.
If the USB hard disk's file system has been damaged,
restarting the NVR will not solve the problem and
the aforementioned error message will continue to
be displayed each time you attempt a backup. If this
is the case, you will need to format the HDD or use a
recovery program to repair the damage to the drive's
file system.
6 Motion Search
(This function supports only in single screen.)
Motion Search cannot be performed while using a split
screen layout. Select Single Screen mode.
• Select First under From and Last under To to search
the recording from start to finish. Alternatively, you
can uncheck the First and Last options and specify
the search time frame manually.
• Type: Motion Search looks for motion in the selected
area by comparing individual frames against their
preceding frames. This means slow and gradual
movements, no matter how long they persist, will not
be recognized. In contrast, Museum Search looks
for changes in the specified area by using the From
frame as a reference. Museum Search, therefore,
recognizes even minute deviations from the original
From frame.
• The Zone setting can be configured in the identical
manner as the Zone setting under System Setup -
Motion Detection. For more information, refer to the
Motion on page 45
.
Museum Search may not function properly if the
edge of the object is included in the Zone. For more
accurate search results, set the inside of the object's
edge as the detection zone.
• Sensitivity: Set to between 1 (Low) and 5 (High).
• Min. Blocks: The Min. Blocks option is available with
Motion Search only.
Once all the options have been configured, select
Search. Select search results entry to display the video
recording on the left. To play the recording, exit the
setup window by selecting Close.