Eneo PNR-5304/4TB - Manual (Page 59)

Part 3 - Configuration
59
3 Pattern
Used to set up a pattern profile for the camera to
follow along.
• Start recording: Select a pattern number, enter
a name for the pattern, and then click OK to save
the pattern. Move the camera using directional,
zoom, and focus buttons and then click Stop
recording to save the pattern profile. You can
record up to two minutes of movement.
- Directional Buttons ( ):
Used to tilt and pan the camera.
- Zoom ( ): Zoom in and out.
- Focus ( ): Adjust camera focus to far or
near.
- Speed: Specify the camera's panning and tilting
speed.
• Test: Select a pattern profile and then click Test to
test it.
• Edit: Used to edit the selected pattern profile.
• Remove: Used to remove the selected pattern
profile.
4 Tour
Used to set up a tour profile of multiple functions in
a designated sequence.
• Set: Used to set up a tour profile.
- Name: Enter a name for the tour profile.
- No.: Indicates the order of the function in the
tour sequence.
- Dwell Time (sec.): Specify how long to perform
the selected function for.
- Speed: Specify the preset speed.
• Test: Select a tour profile and then click Test to
test it.
• Edit: Used to edit the selected tour profile.
• Remove: Used to remove the selected tour profile.
Select Apply after setting up a preset, scan,
pattern, or tour profile to see images from the
concerned camera on the left side of the screen.
Selecting Apply or OK displays a popup screen
that indicates whether the profile has been set up
successfully.
5 Home Position: Specify the camera's home
position.
• Default: Uses the factory-default position as the
camera's home position.
• Custom: Uses the user-defined position as the
home position.
• Select Set to change the home position.
6 Auto Run: Specify which action to take if the
camera has not been controlled for the specified
duration of time.
7 Auto Pan: Specify the camera's panning
direction. When Auto Pan is selected from
a remote program, the camera pans in the
direction selected here.