H3C Technologies H3C S12500 Series Switches - Manual (Page 350)

334
# After all switches function correctly, perform a master/backup switchover on Switch A to trigger
an OSPFv3 GR operation.
Configuring BFD for OSPFv3
Network requirements
As shown in Figure 112 , configure OSPFv3 on Switch A, Switch B and Switch C and configure BFD over
the link Switch A<—>L2 Switch<—>Switch B.
After the link Switch A<—>L2 Switch<—>Switch B fails, BFD can quickly detect the failure and notify
OSPFv3 of the failure. Then Switch A and Switch B communicate through Switch C.
Figure 112 Network diagram
Device Interface IPv6 address Device Interface IPv6 address
Switch A Vlan-int10 2001::1/64 Switch B Vlan-int10 2001::2/64
Vlan-int11 2001:2::1/64 Vlan-int13 2001:3::2/64
Switch C Vlan-int11 2001:2::2/64
Vlan-int13 2001:3::1/64
Configuration procedure
1. Configure IP addresses for the interfaces. (Details not shown.)
2. Configure basic OSPFv3:
# Configure Switch A, enable OSPFv3, and configure the router ID as 1.1.1.1.
<SwitchA> system-view
[SwitchA] ipv6
[SwitchA] ospfv3
[SwitchA-ospfv3-1] router-id 1.1.1.1
[SwitchA-ospfv3-1] quit
[SwitchA] interface vlan-interface 10
[SwitchA-Vlan-interface10] ospfv3 1 area 0
[SwitchA-Vlan-interface10] quit
[SwitchA] interface vlan-interface 11
[SwitchA-Vlan-interface11] ospfv3 1 area 0
[SwitchA-Vlan-interface11] quit
# Configure Switch B, enable OSPFv3, and configure the router ID as 2.2.2.2.
<SwitchB> system-view