Network requirements – H3C Technologies H3C S12500 Series Switches User Manual

Page 65

Advertising
background image

49

State: Inactive Adv Age: 00h12m50s

Tag: 0

# Enable RIP event debugging on Switch A.

<SwitchA> debugging rip 1 event

<SwitchA> terminal debugging

%Jan 19 10:41:51:203 2008 SwitchA BFD/4/LOG:Sess[192.168.1.1/192.168.1.2,

Vlan-interface 100,Ctrl], Sta: UP->DOWN, Diag: 1

*Jan 19 10:33:12:813 2008 SwitchA RM/6/RMDEBUG: RIP-BFD: Message Type Disable, Connect

Type Direct-connect, Pkt Type Echo, Src IP Address 192.168.1.1, Src IFIndex4, Nbr IP

Address 192.168.1.2.

The output shows that when the link over VLAN-interface 100 fails, Switch A can quickly detect the
change.
# Display the BFD information on Switch A.

<SwitchA> display bfd session

The output shows that Switch A has deleted the BFD session on VLAN-interface 100 to Switch C
and displays no output.
# Display the RIP routes of RIP process 1 on Switch A.

<SwitchA> display rip 1 route

Route Flags: R - RIP, T - TRIP

P - Permanent, A - Aging, S - Suppressed, G - Garbage-collect

----------------------------------------------------------------------------

The output shows that the RIP route learned from Switch C no longer exists.
# Display routes destined for 100.1.1.0/24 learned on Switch A.

<SwitchA> display ip routing-table 100.1.1.0 24 verbose

Routing Table : Public

Summary Count : 1

Destination: 100.1.1.0/24

Protocol: RIP Process ID: 2

Preference: 100 Cost: 2

IpPrecedence: QosLcId:

NextHop: 192.168.2.2 Interface: vlan-interface 200

BkNextHop: 0.0.0.0 BkInterface:

RelyNextHop: 0.0.0.0 Neighbor : 192.168.2.2

Tunnel ID: 0x0 Label: NULL

BKTunnel ID: 0x0 BKLabel: NULL

State: Active Adv Age: 00h18m40s

Tag: 0

Configuring BFD for RIP (bidirectional control detection)

Network requirements

Switch A is connected to Switch C through Switch B, as shown in

Figure 16

. VLAN-interface 100 on

Switch A and VLAN-interface 200 on Switch C run RIP process 1.
Configure a static route to Switch C on Switch A, and configure a static route to Switch A on Switch C.
Enable BFD on VLAN-interface 100 of Switch A and VLAN-interface 200 of Switch C.

Advertising