H3C Technologies H3C S12500 Series Switches - Manual (Page 40)

24
• RFC 2082, RIPv2 MD5 Authentication
• RFC 2091, Triggered Extensions to RIP to Support Demand Circuits
• RFC 2453, RIP Version 2
RIP configuration task list
Task Remarks
Configuring basic RIP Required.
Configuring RIP route
control
Configuring an additional routing metric Optional.
Configuring RIPv2 route summarization Optional.
Disabling host route reception Optional.
Advertising a default route Optional.
Configuring inbound/outbound route filtering Optional.
Configuring a priority for RIP Optional.
Configuring RIP route redistribution Optional.
Tuning and optimizing
RIP networks
Configuring RIP timers Optional.
Configuring split horizon and poison reverse Optional.
Configuring the maximum number of ECMP routes Optional.
Enabling zero field check on incoming RIPv1
messages
Optional.
Enabling source IP address check on incoming RIP
updates
Optional.
Configuring RIPv2 message authentication Optional.
Specifying a RIP neighbor Optional.
Configuring RIP-to-MIB binding Optional.
Configuring the RIP packet sending rate Optional.
Configuring RIP FRR Optional.
Configuring BFD for RIP
Configuring single-hop echo detection Optional.
Configuring bidirectional control detection Optional.
Configuring basic RIP
Configuration prerequisites
Before you configure RIP basic functions, complete the following tasks:
• Configure the link layer protocol.
• Configure IP addresses for interfaces to ensure IP connectivity between neighboring nodes.