H3C Technologies H3C S7500E Series Switches - Manual (Page 43)

33
Figure 26 PSR6000-ACV panel
(1) Captive screw (2) PoE power switch (O: off; —: on)
(3) Power module status LED (4) Fastening screw holes for the power cord retainer suite
(5) System power socket (6) System power switch (O: off; —: on)
(7) Power module handle (8) PoE power sockets
To attach the power cord retainer suite:
1. Fasten the retainer suite to the plug of the power cord. Attach the left and right parts of the retainer
suite to the power cord according to the relative positions shown in
Figure 27 .
2. Use a Phillips screwdriver to fasten the two parts of the retainer suite together.
Figure 27 Attaching the power cord retainer suite
(1) Screw holes for connecting the retainer suite to the power module (2) Power cord plug
(3) Screw holes for connecting the two parts of the retainer suite
3. Connect the power cord into the power socket of the power module.
If you cannot align the screw holes on the retainer suite with those on the power module, pull the
cable retainer suite outwards, rotate it by 180 degrees, and push it in until it is secured in place.
Then, you can align the screw holes in the retainer suite with the screw holes in the power module.