H3C Technologies H3C S7500E Series Switches - Manual (Page 73)

63
Replacing an XFP/SFP+/SFP/QSFP+ module
1. Wear an ESD wrist strap and make sure it has a good skin contact and is reliably grounded. For
more information, see "Installing FRUs."
2. Remove the optical fibers on the module.
3. Pivot the clasp down to the horizontal position.
For a QSFP+ module that uses a plastic pull latch, skip this step. QSFP+ modules use either a metal
or plastic pull latch.
4. Grasp the clasp on the module and carefully pull the module out of the slot.
5. Put the dust plug on the removed module, and put the remove module into its original shipping
materials.
6. Install a new module.
For the installation procedures, see "Installing FRUs."
7. Connect fibers to the new module.
Figure 58 Removing an SFP+ transceiver module
Replacing a CFP module
1. Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
For more information, see "Installing FRUs."
2. Remove the optical fibers on the module.
3. Loosen the captive screws on the module.
4. Carefully pull the module out of the slot.
5. Put the dust plug on the removed module, and put the removed module into its original shipping
materials.