Replacement procedures, Replacing mounting brackets – H3C Technologies H3C S7500E Series Switches User Manual
Page 63
53
Replacement procedures
CAUTION:
•
Ensure electrical safety when you hot swap an FRU.
•
To avoid bodily injury and device damage, strictly follow the replacement procedure in this section when
you replace a component.
All FRUs of the S7500E series switches are hot swappable. You can replace any of them when the switch
is operating. Figures for the chassis and FRUs are for illustration only.
Replacing mounting brackets
1.
Remove the screws that secure the chassis to the rack.
2.
Cooperate with one or more people to lift the chassis by holding chassis handles or by supporting
the chassis bottom. Pull out the chassis along the guide rails until the space is enough for replacing
the mounting brackets.
Figure 45 Pulling out the chassis (S7503E)
3.
Remove the mounting brackets, as shown in