H3C Technologies H3C WA2600 Series WLAN Access Points - Manual (Page 59)

8-8
# Create a clear-type WLAN service template, configure its SSID as market, configure its
authentication method as open-system, and then enable the WLAN service template.
[AP] wlan service-template 1 clear
[AP-wlan-st-1] ssid market
[AP-wlan-st-1] authentication-method open-system
[AP-wlan-st-1] service-template enable
# Configure the radio type as 802.11g for radio interface WLAN-Radio 1/0/2, and bind service template
1 to interface WLAN-BSS1 on the radio interface.
[AP] interface WLAN-Radio1/0/2
[AP-WLAN-Radio1/0/2] radio-type dot11g
[AP-WLAN-Radio1/0/2] service-template 1 interface wlan-bss 1
# Configure radio interface WLAN-radio 1/0/2 to allow up to 10 users to use high-priority AC queues
(including AC-VO and AC-VI).
[AP-WLAN-Radio1/0/2] wmm edca client ac-vo cac
[AP-WLAN-Radio1/0/2] wmm edca client ac-vi cac
[AP-WLAN-Radio1/0/2] wmm cac policy users 10
[AP-WLAN-Radio1/0/2] wmm enable
[AP-WLAN-Radio1/0/2] quit
If a client wants to use a high-priority AC (AC-VO or AC-VI), it must send a request to the AP. If the
number of clients using high-priority ACs (AC-VO and AC-VI) plus the clients requesting for high-priority
ACs (AC-VO and AC-VI) on AP 1 or AP 2 is smaller than or equal to the maximum number of
high-priority AC clients (10 in this example), the request is accepted; otherwise, the request is denied.
Troubleshooting
EDCA Parameter Configuration Failure
Symptom
Configuring EDCA parameters for an AP failed.
Analysis
The EDCA parameter configuration of an AP is restricted by the radio chip of the AP.
Solution
1) Use the display wlan wmm radio ap ap-name command to view the support of the radio chip for
the EDCA parameters. Make sure the configured EDCA parameters are supported by the radio
chip.
2) Check that the values configured for the EDCA parameters are valid.
SVP or CAC Configuration Failure
Symptom
The SVP packet priority mapping function configured with the wmm svp map-ac command does not
take effect.
CAC configured with the wmm edca client command does not take effect.
Analysis
The SVP packet priority mapping function or CAC takes effect only after WMM is enabled.