H3C Technologies H3C WA2600 Series WLAN Access Points - Manual (Page 68)

9-8
[AP1-WLAN-Radio1/0/1] mesh-profile 1
The configuration of AP 2 is the same as that of AP 1. You only need to configure the peer MAC address
as the MAC address of AP 1.
Configuration verification
After the devices on the two ends of the WDS link are configured, you can use the display command to
view whether the WDS link has been established successfully.
# View the WDS link information on AP 1.
<AP1> display wlan mesh-link all
Peer Link Information
-------------------------------------------------------------------------------
Nbr-Mac BSSID Interface Link-state Uptime (hh:mm:ss)
0ebb-01bb-bb00 000f-e212-1200 WLAN-MESHLINK62 Active 0:17:59
-------------------------------------------------------------------------------
The output information shows that the WDS link between AP 1 and AP 2 has been established
successfully.
WDS Point to Multi-Point Configuration Example
Network requirements
z As shown in the following figure, AP 1, AP 2, AP 3, and AP 4 are connected to different LAN
segments.
z It is required that AP 1 establish a WDS link with AP 2, AP 3, and AP 4 respectively.
Figure 9-5 WDS point to multi-point configuration
Configuration procedure
WDS point-to-multi-point configuration is the WDS point-to-point configuration. Note the following when
configuring WDS:
z Configure a neighbor MAC address for each radio interface (otherwise, WDS links may be set up
between AP 2, AP 3, and AP 4).
z Set the maximum number of WDS links allowed. The default value is 2. It should be set to 3 for AP
1 in this example.
Configuration verification
z It is displayed that AP 1 has established a WDS link with AP 2, AP 3 and AP 4 respectively after
execution of the display wlan mesh-link all command on AP 1.
z It is displayed that AP 2, AP 3 and AP 4 have respectively established a WDS link with AP 1 after
execution of the display wlan mesh-link all command on them.