H3C Technologies H3C WA2600 Series WLAN Access Points - Manual (Page 65)

9-5
To do… Use the command… Remarks
Configure the link saturation RSSI link-saturation-rssi value
Optional
100 dBm by default
Configure the probe request
interval probe-request-interval
interval-value
Optional
By default, the probe request interval is
1000 ms.
Configure the link rate mode
link rate-mode { fixed |
real-time }
Optional
The default link rate mode is fixed.
Mapping a Mesh Profile to the Radio of an MP
To enable a WDS service, a mesh profile must be mapped to the radio of the MP.
Follow these steps to map a mesh profile to a radio:
To do… Use the command… Remarks
Enter system view system-view —
Enter radio interface view interface wlan-radio interface-number —
Map the mesh profile to the
radio interface
mesh-profile mesh-profile-number
Required
By default, no mesh profile is
mapped to the radio.
z The WLAN mesh interface of the MP will be created if the MP is in running state and the mapped
mesh profile is enabled.
z You need to manually specify the working channels of the radios on the two APs for which a WDS
link is to be established, and the working channels must be the same.
Mapping an MP Policy to the Radio of an MP
An MP policy should be mapped to a radio so that link formation and maintenance on the radio can be
driven by the attributes specified in the MP policy.
Follow these steps to map an MP policy to the radio:
To do… Use the command… Remarks
Enter system view system-view —
Enter radio interface view
interface wlan-radio
interface-number
—
Map the MP policy to the
radio
mp-policy my-policy-name
Required
By default, the default MP policy
“default_mp_plcy” is adopted for the radio.