Yaskawa i80M Connecting Manual - Manual (Page 7)

3 ENVIRONMENTAL CONDITIONS
The following are conditions for the location where the control panel is installed by the machine
manufacturer. Therefore, when working on design, observe the “CONDITIONS FOR CABINET
CONSTRUCTION DESIGN” described in Section 4 and design the unit so as to meet the
following conditions.
3.1 AMBlENT TEMPERATURE
●
During operation: O to
. During storage and transport: –20 to
Even if the ambient temperature is less than , do not install the control panel in
direct sunlight or near heat sources or in the open air.
3.2 H U M I D I T Y
Under normal conditions: Relative Humidity: 10 to 90% (non-condensing)
3.3 VIBRATION
During operation :0.5 G or less
3.4 OPERATING ENVIRONMENT
Do not use in dusty environment or where cutting oil/fluids or organic solvents are present in
the air.
7