Yaskawa i80M Connecting Manual - Manual (Page 92)

(2) Output Circuits
Polar no-contact outputs are used. The operating current must not exceed (per circuit).
The 24 V power supply is allowed to use either the internal power source or an external power
source,
When the internal power source is used
JANCD-FC800
I
—
(b) When an external power source is used
JANCD-FC800
Load
+ —
NOTE: The output circuit power source . . . 11 in total) can be selected for every 8 output
points.
Perform setup by making appropriate wiring connections on the cable side.
Fig. Output Circuits
(3) Input Signal Waveform
PLC SIGNAL
Operation Delay Time
Chattering Time
Fig. 18.7
9
9 2