Riello UPS PowerShield³ - Manual (Page 6)

6 • Quick start guide UPSMON User Manual
II. Quick Start Guide
1. Quick start guide to installing the software
1. Make a note of the UPS PRTK code, this code is located on a label that will be positioned on either the front or the rear
of the UPS (e.g. SENTR……).
2. If the connection to the UPS is to be made via a serial or USB port install the software and when prompted enter the
PRTK code.
3. If the connection to the UPS(s) is to be made via a network using a NetMan adaptor, first setup the NetMan following the
NetMan user manual, the most important information required for the NetMan is the IP address, netmask and the router
address, all of which are entered via option 1 of the Netman main menu screen.
4. Enter the PRTK code (from note 1) into the Netman via option 5 of the Netman main menu.
5. Once the software is installed, select Upsetup followed by the UPS configuration tab, then enter the PRTK code and the
method of communication (ensure to use the correct IP address as set in the Netman).
6. For further information refer to this User Manual.