RIGOL DM3058 - Manual (Page 44)

RIGOL
User’s Guide for DM3058/DM3058E 2-22
To Test Continuity
When the measured resistance in circuit is lower than selected one, it is considered
being connected by instrument. Next, we will introduce you how to test continuity
for circuit by using DM3058/DM3058E step by step to make you familiar with this
technique.
Operating Steps:
1. Press to enter into the following interface.
Figure 2-26 Continuity Testing Interface
2. Connect test leads as the figure below. Red lead connects with HI terminal;
Black lead connects with LO terminal.
Figure 2-27 Sketch map for testing
3. Set the Short-circuit resistance.
Press Set to set up the resistance of short-circuit. The default value is set as
10Ω when leaving factory. Users may carry on the Continuity measurement
directly without modification.
Open or Closed Circuit
I