Freescale Semiconductor MC68HC908MR32 - Manual (Page 182)

System Integration Module (SIM)
MC68HC908MR32 • MC68HC908MR16 Data Sheet, Rev. 6.1
182 Freescale Semiconductor
Figure 14-1. SIM Block Diagram
14.2 SIM Bus Clock Control and Generation
The bus clock generator provides system clock signals for the CPU and peripherals on the MCU. The
system clocks are generated from an incoming clock, CGMOUT, as shown in
Figure 14-2 . This clock
can come from either an external oscillator or from the on-chip phase-locked loop (PLL) circuit. See
Chapter 4 Clock Generator Module (CGM) .
14.2.1 Bus Timing
In user mode, the internal bus frequency is either the crystal oscillator output (CGMXCLK) divided by four
or the PLL output (CGMVCLK) divided by four. See
Chapter 4 Clock Generator Module (CGM) .
14.2.2 Clock Startup from POR or LVI Reset
When the power-on reset (POR) module or the low-voltage inhibit (LVI) module generates a reset, the
clocks to the CPU and peripherals are inactive and held in an inactive phase until after the 4096
CGMXCLK cycle POR timeout has completed. The RST pin is driven low by the SIM during this entire
period. The internal bus (IBUS) clocks start upon completion of the timeout.
WAIT
CLOCK
CONTROL
CLOCK GENERATORS
POR CONTROL
RESET PIN CONTROL
SIM RESET STATUS REGISTER
INTERRUPT CONTROL
AND PRIORITY DECODE
MODULE WAIT
CPU WAIT (FROM CPU)
SIMOSCEN (TO CGM)
CGMOUT (FROM CGM)
INTERNAL CLOCKS
MASTER
RESET
CONTROL
RESET
PIN LOGIC
LVI (FROM LVI MODULE)
ILLEGAL OPCODE (FROM CPU)
ILLEGAL ADDRESS (FROM ADDRESS
MAP DECODERS)
COP (FROM COP MODULE)
INTERRUPT SOURCES
CPU INTERFACE
RESET
CONTROL
SIM
COUNTER
COP CLOCK
CGMXCLK (FROM CGM)
ч 2