2 pll bandwidth control register, Pll bandwidth control register, Se clock, cgmout. see – Freescale Semiconductor MC68HC908MR32 User Manual
Page 67: 2 pll, Bandwidth control register, If pll interrup, T (see
CGM Registers
MC68HC908MR32 • MC68HC908MR16 Data Sheet, Rev. 6.1
Freescale Semiconductor
67
if the PLL is off. Therefore, PLLON cannot be cleared when BCS is set, and
BCS cannot be set when PLLON is clear. If the PLL is off (PLLON = 0),
selecting CGMVCLK requires two writes to the PLL control register. See
4.3.3 Base Clock Selector Circuit
PCTL[3:0] — Unimplemented Bits
These bits provide no function and always read as logic 1s.
4.5.2 PLL Bandwidth Control Register
The PLL bandwidth control register (PBWC):
•
Selects automatic or manual (software-controlled) bandwidth control mode
•
Indicates when the PLL is locked
•
In automatic bandwidth control mode, indicates when the PLL is in acquisition or tracking mode
•
In manual operation, forces the PLL into acquisition or tracking mode
AUTO — Automatic Bandwidth Control Bit
This read/write bit selects automatic or manual bandwidth control. When initializing the PLL for manual
operation (AUTO = 0), clear the ACQ bit before turning on the PLL. Reset clears the AUTO bit.
1 = Automatic bandwidth control
0 = Manual bandwidth control
LOCK — Lock Indicator Bit
When the AUTO bit is set, LOCK is a read-only bit that becomes set when the VCO clock, CGMVCLK,
is locked (running at the programmed frequency). When the AUTO bit is clear, LOCK reads as logic 0
and has no meaning. Reset clears the LOCK bit.
1 = VCO frequency correct or locked
0 = VCO frequency incorrect or unlocked
ACQ — Acquisition Mode Bit
When the AUTO bit is set, ACQ is a read-only bit that indicates whether the PLL is in acquisition mode
or tracking mode. When the AUTO bit is clear, ACQ is a read/write bit that controls whether the PLL is
in acquisition or tracking mode.
In automatic bandwidth control mode (AUTO = 1), the last-written value from manual operation is
stored in a temporary location and is recovered when manual operation resumes. Reset clears this bit,
enabling acquisition mode.
1 = Tracking mode
0 = Acquisition mode
Address: $005D
Bit 7
6
5
4
3
2
1
Bit 0
Read:
AUTO
LOCK
ACQ
XLD
0
0
0
0
Write:
R
R
R
R
R
Reset:
0
0
0
0
0
0
0
0
R
= Reserved
Figure 4-6. PLL Bandwidth Control Register (PBWC)