Fostex VF160EX - Manual (Page 100)

100
Selecting a program in the chain play list
If the play mode is set to any option but “Off”, you can
select a program only from those set to the chain play
list. By selecting a program, you can start chain play
from the desired step in the chain play list.
1. While the recorder is stopped, press the [PGM SEL] key.
After showing “Select Change No!” immediately, the
display changes to show the screen as below, on which
the current program list number and “Sure?” flash.
In this condition, you can select another program set in
the list by rotating the [JOG] dial.
<Note>
If you want to select any program on the disk, as usual,
turn off the power and then on, or set the chain play
mode to “Off” (see “Setting the chain play mode”).
In the following procedure, it is assumed that the chain
play list has been made, the play mode is set to an
option but “Off”, and the program set to the first step
of the chain play list is loaded.
2. Use the [JOG] dial to select the desired step and press
the [ENTER/YES] key.
The program set to the selected step is loaded and the
recorder is stopped at the beginning of the program (ABS
0), while the display shows the Normal screen.
In the screen examples below, program 4 (P04) set to step
4 (C04) is selected.
As described above, by selecting a program while the
chain play mode is set to any option but “Off”, you
can start chain play from the desired program.
Editing the chain play list
You can replace a program in the chain play list with
another program, delete a program from the list, or
add a new program to the list.
• Deleting (or replacing) a program in the chain play list
You can delete a desired program from the chain play
list or replace a program in the list with another program
by following the procedure below.
1. While the recorder is stopped, press the [SETUP] key
to enter the setup mode.
The screen for selecting a menu item in the setup mode
appears.
2. Use the [JOG] dial to select “Chain Play List”, and press
the [ENTER/YES] key.
The display changes to shows the “Chain Play List” screen
as below.
3. Use the [JOG] dial to select the step you want to edit,
and press the [ENTER/YES] key.
The program number set to the selected step starts
flashing.
In the example below, “P03” which is set to step 3 (C03)
is flashing.
4. Use the [JOG] dial to select “DEL” (or a desired program)
and press the [ENTER/YES] key.
To delete the program from the chain play list, select
“DEL”. To replace the program with another program,
select a desired program.