Fostex VF160EX - Manual (Page 37)

37
flashing
Punch IN/OUT recording enables you to record over previously recorded parts. This function comes in handy in
the following cases.
* If a recording is unsatisfactory in either recording or performance and you want to redo it.
* If you want to record a solo part to another track while listening to the backup tracks.
PUNCH IN refers to the process to switching from PLAY to REC. On the other hand, PUNCH OUT refers to the reverse
process, to switch from REC to PLAY. The time to punch in is called the PUNCH IN point, and the time to punch out
is called the PUNCH OUT point. The VF160EX features the following 3 types of PUNCH IN/OUT modes.
* MANUAL PUNCH IN/OUT using the key on the main unit
This feature is used for rough recordings. Manual punch in/out is not recommended during a performance since the process
requires using your hands.
* PUNCH IN/OUT using the foot switch
Recording is possible even during a performance since all punch in/out processes are controlled from the foot switch.
* AUTO PUNCH IN/OUT
Detailed recording is possible since recording takes place with the punch in/out time preset (programmed) prior to the
recording.
Use the [DIRECT-REC TRK] key to put the track to record in the READY mode. The [TRIM] must be adjusted to an optimal
gain according to the input monitor. When this is set, do the following:
Manual Punch IN/OUT
Punch IN/OUT with Foot switch
Tips: Rehearsal
Step on the foot switch while the [STOP] key is depressed
to start rehearsing the recording (“ Rhrsl On ” will appear
on the LCD then “ RHSL ” will light ON).
Rehearsal instructions are the same as recording with
the foot switch.
However, stepping on the foot switch will go to input
monitor, and stepping on it again will cancel it. To cancel
the rehearsal mode, step on the foot switch again while
the
[STOP] key is depressed (“ Rhrsl Off ” will appear on
the LCD then “ RHSL ” will light OFF).
1. Press the [PLAY] key from the point immediately before
starting the recording and then playback.
2. Press the [RECORD] key while the [PLAY] key is
depressed to start recording (punch in).
3. Recording is canceled and playback takes place if only
the [PLAY] key is pressed (punch out).
1. Connect a “Fostex Model 8051” foot switch to the [FOOT
SW] jack on the rear panel of the VF160EX.
2. Press the [PLAY] key from the point immediately before
starting the recording, then playback.
3. Recording starts by stepping on the foot switch (punch
in).
4. Recording is canceled and playback takes place when the
foot switch is stepped on again (punch out).
2 1 R L
IN OUT
IN OUT
AVIS:
OPTICAL
AC-IN POWER FOOT SW DIGITAL/DATA MIDI ST OUT AUX SEND
CAUTION
RISK OF ELECTRIC SHOCK DO NOT OPEN
RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS EQUIPMENT
TO RAIN OR MOISTURE.
Foot Switch
Tips: Foot Switch
Use the optional Fostex Model 8051 or a universal
foot switch of the unlatched type.
Punch In/Out
Step on the foot switch.
(Punch In)
Recording Track
Playback Record Playback
Step on the foot switch again.
(Punch Out)
Press [RECORD] key while holding the [PLAY] key.
(Punch In)
Recording Track
Playback Record Playback
Press the [PLAY] key only.
(Punch Out)